I used JB Weld PlasticWeld to thicken and lengthen the ends of the trident prongs after cleaning and roughening the ends with sandpaper.
It was easy to shape by gently forming the PlasticWeld with fingers only. It set hard after about 4 hours.
The modified aneros is comfy enough to wear for hours now.
Use a lighter to slowly soften and then reshape the arms (place under cold water to set the plastic in position) – in order to shift where the tip of the aneros reaches inside you.
Experiment,
Make your aneros work for you. https://imgur.com/DC4s9TQ.jpg
I’ve done something similar with Sugru for the P-tab on my trident. Good stuff!
I need to do this. That back one is really uncomfortable. I feel like making it wider as well as longer would help, bulking up the knob so it’s closer to the middle. Thanks for this.
Wish I could upvote this again. I just finished smoothing out the JB Weld with some wet sanding. Talk about a pain in the ass! I built the front knob to be larger and with a slightly flatter top. The rear knob, I built it more towards the center, and so that it’s now maybe a half an inch wide, and about an inch long, with a wider rounded top. VERY comfy. I’ve been walking around with it for over an hour now, and no uncomfortable pressure points… especially near the tailbone.
Sitting in a padded rocker and still comfortable while rocking.